Bare overhead Conductors: AAC, AAAC and ACSR
News Details
Two aerial cables can have the same nominal cross-section, but differ in weight, resistance and tensile strength. Such differences can affect tower loads, ground clearance and whether the existing fittings will fit. That is why an offer prepared only by section can later cause problems.
Shenghua Cable Group produces bare aerial conductors for power transmission and distribution. Its product range includes all-aluminum, aluminum-alloy and steel-reinforced designs. For energy suppliers, EPC contractors and distributors, the correct order begins with matching the conductor to the line design.
Compare AAC, AAAC and ACSR designs
| Conductor | Design | What buyers should review |
| AAC conductor | Stranded aluminum | Compare resistance, weight and calculated tensile strength with the approved span design. |
| AAAC conductor | Stranded aluminum alloy without steel core | Check the alloy grade, resistance and strength. Compare the design with local corrosion conditions. |
| ACSR conductor | Aluminum strands around a steel core | Specify the number of aluminum and steel strands, core coating and calculated tensile strength. |
Shenghua's AAAC catalogue lists examples from 18.8 to 996 mm², with code names such as Box, Pine, Totara and Redwood. Include the applicable standard and strand construction in your inquiry so the factory can identify the exact item.
Check the span before approving a replacement
A replacement conductor must work with the existing poles or towers. Start with the approved values for span length, conductor weight, calculated tensile strength and operating temperature. Then have the line designer check sag and tension under the project's wind, ice and temperature conditions.
For example, a utility company may consider switching from ACSR to AAAC on a coastal feeder. Even if the proposed AAAC meets the electrical resistance target, the change can affect sag, support loads and fitting selection. Check these items before approving the replacement.
Match the conductor to its line fittings
Check the finished diameter and strand design of the conductor against the approved suspension clamps, dead ends and joints. Diameter is a useful first check. However, a fitting may also have limitations in terms of conductor material or construction.
For replacement orders, share the existing conductor schedule and fitting references with Shenghua. If the project uses steel-reinforced conductors, specify whether the requested cross-section refers to the aluminum part or the entire conductor. This distinction helps the factory quote the correct design.
Specify the standard and factory inspections
IEC 61089 defines electrical and mechanical properties for aerial conductors made of round wires stranded in concentric layers. If the utility uses this standard, specify the required edition and amendments in the purchase order. If it uses its own specification, attach this document to the inquiry.
Agree on the evidence required for acceptance. Depending on the contract, this may include the number and diameter of the strands, the finished conductor diameter, mass per unit length, DC resistance and tensile test results. For ACSR, include the requirements for the steel core and coating. Ask the manufacturer to identify which results apply to the ordered batch and which to the conductor design.
Order drum lengths according to pull section
A total quantity in kilometers tells the factory how much conductor you need. A drum schedule tells them how to divide that quantity.
List the required length for each planned pull, as well as any restrictions on drum diameter, gross weight and unloading access. If the route has restricted joint locations, mark them before the drum lengths are agreed. For phased deliveries, request drum labels identifying the conductor code, net length and intended work section.
Request a quote for bare conductor from Shenghua
Send your conductor schedule or utility specification via the inquiry form on the relevant Shenghua product page. Include:
-
Conductor type, code name and applicable standard
-
Nominal cross-section, number of strands and strand diameter
-
Required DC resistance and calculated tensile strength
-
Core material and coating, if applicable
-
Total quantity, drum lengths and inspection requirements
-
Delivery destination and required dates
If you are comparing AAC, AAAC and ACSR, request a data sheet for each proposed design. This gives the engineering and procurement teams a common basis for evaluating performance, fitting compatibility and delivered costs.